- Safe & easy way to keep your pet's nails trimmed
- The plastic track has a soft sand abrasive material permanently bonded to it
- Tracks fit into Exotic Nutrition's Silent Runner Wheel 9" - **THIS IS ONLY TRACK, WHEEL SOLD SEPARATELY**
- Washable for easy maintenance
- Package sets available - wheel + sandy track + cage attachment
- Nailtrimmer Track for 9" Yellow Silent Runner Wheel
Exotic Nutrition's Sandy Trimmer Track fits into the Silent Runner 9" small wheel for nail trimming use.
Pet nails can grow to be long and sharp. Not only can this be uncomfortable or even painful to you as an owner, it can also cause your pet to frequently get stuck on fabrics, like pouches or clothing. Nail trimming using clippers can be difficult and may even cause injury to your pet if done incorrectly. Sandy Trimmer Tracks provide a soft, abrasive running surface for your pet while using their exercise wheel. Simply install the sandy track in place of the regular track, it takes less than a minute, and your pet’s nails will be naturally filed down as they run (see assembly instructions and video below). Replace the sandy track with the regular track after 2-3 days (or when nails are filed) and repeat weekly. This track is completely safe and will not cause harm or discomfort to your pet if used as instructed. Conveniently hand-washable and reusable to last the lifetime of your pet.
Notice: It may be necessary to initially trim pet's nails with clippers then maintain the nail through frequent use of the sandy track
ASSEMBLY INSTRUCTIONS: Remove the standard running track on your Silent Runner wheel. Begin by inserting the corner of the Sandy Track into the molded edges of the back panel (black) for the Silent Runner wheel. Once the corner edge is pushed in, begin working the sandy track all the way around the wheel into the groove. Once completely in the groove, push the clear connector into place connecting both ends of the track. Set the front wheel panel on the sandy track, and starting with the side away from the connector, work one small section of the sandy track into the front wheel panel groove (panel with the openings). Once a small section of the track is in the groove, apply pressure (squeeze down) all the way around the wheel until the track is in place. You may need to push the last section near the clear connector in with your fingers. Set the wheel down on a hard, flat surface and apply pressure all the way around the wheel to secure the track in place.